Home/Locations/Mentmore, NM/EV Charger Installation

EV Charger Installation in Mentmore, NM

A Level 2 charger at home turns an overnight trickle into a full battery by morning. Lebogang Electrical Services handles EV charger installation in Mentmore for every make: Tesla, Ford, Chevy, Rivian, Hyundai, Kia and the rest. We check your panel capacity, run the 240 volt circuit and mount and test the charger, anywhere in McKinley County.

Call (888) 633-7804 All services in Mentmore

EV Charger Installation in Mentmore: what's included

Level 2 home EV charging station installation
Tesla Wall Connector installation
NEMA 14-50 outlet installation for mobile chargers
Dedicated 240 volt circuit from the panel
Load calculation and load management options
Indoor, outdoor and detached garage installs

Level 2 charger installation in Mentmore

Level 2 charging runs on 240 volts and typically adds 25 to 40 miles of range per hour, against 3 to 5 miles from a wall outlet. A Level 2 charger installation in Mentmore usually means a dedicated 40 to 60 amp circuit from the panel to the garage or driveway, with the charger hardwired or plugged into a 14-50 receptacle.

Tesla charger installation and Tesla Wall Connector installation

The Tesla Wall Connector charges at up to 48 amps on a 60 amp circuit. Our Tesla charger installation in Mentmore includes mounting, wiring, setting the charger to match the circuit and testing with your car. We also install the Universal Wall Connector and adapters for other vehicles.

Home EV charging station: will my panel handle it?

An EV charger is a continuous load, so it counts heavily in the load calculation. Many 200 amp homes have room. Homes with 100 amp service may need a load management device or a panel upgrade. Our EVSE installation service checks this before any wire is pulled.

What we check before an EV charger installation in Mentmore

Spare capacity on your electrical service
Open breaker spaces in the panel
Distance from the panel to the parking spot
Indoor or outdoor mounting and cable reach
Your vehicle's maximum charging rate

Electrical work in Mentmore and McKinley County

Many properties around Mentmore run a 100 amp service that was sized years ago. Add a shop with a welder, a second well pump, a mini-split or an EV charger and it's at its limit. We do a load calculation and recommend a sub panel or a service upgrade as needed.

Electric service in McKinley County is typically provided by the City of Gallup, Continental Divide Electric Cooperative or the Navajo Tribal Utility Authority, depending on your address. When a job involves the meter or the service wires, we coordinate the disconnect and reconnect with them. We provide EV charger installation across Mentmore (ZIP code 87319) and in nearby Gallup, Gamerco, Rehoboth, Yatahey and Vanderwagen.

How it works

Call (888) 633-7804Tell us what's happening at your Mentmore property. Emergencies are dispatched straight away. Everything else gets a time that suits you.
Get a price firstThe electrician looks at the job, explains what's needed in plain language and gives you the price before starting.
We do the workWiring is installed to current electrical code, with materials chosen for the location and the load.
Tested and explainedEverything is tested, the panel is labeled where it applies, and the work area is left clean.

EV Charger Installation FAQ for Mentmore

How much does EV charger installation cost in Mentmore?

The main factors are the distance from the panel to the charger, the circuit size and whether the panel has capacity. A short run in an attached garage costs far less than a long run to a detached one.

Do I need a panel upgrade for an EV charger?

Not always. If a load calculation shows spare capacity, we add the circuit. If not, a load management device or a lower charging rate can often avoid a full upgrade.

Hardwired or plug-in?

Hardwired is cleaner, allows higher charging rates and suits outdoor installs. A 14-50 outlet is flexible if you may move the charger or take it with you.

How long does installation take?

Most home installations take two to four hours once the charger is on site.

What customers say

They checked the panel first, explained the options and installed our Level 2 charger in the garage in an afternoon. Price was exactly what they quoted.
Tanya L. EV charger

Our adobe had wiring from who knows when. They rewired it in stages so we could stay in the house and were careful with the plaster. Everything is grounded now.
Angela M. Whole house rewiring

Had three ceiling fans installed where there were only lights before. No wobble, quiet and they hauled away all the boxes.
Susan H. Ceiling fans

Serving Mentmore, NM