Hot Tub Electrical Installation in Texico, NM

Hot Tub Electrical Installation in Texico: what's included

• Dedicated 240 volt GFCI spa circuit
• Spa disconnect panel installation
• Conduit, trenching and wet-location wiring
• Equipment bonding and grounding
• Pool pump, heater and light circuits
• Sauna and swim spa wiring

Hot tub wiring in Texico: what's involved

Most full-size hot tubs need a dedicated 240 volt circuit of 40 to 60 amps with GFCI protection. A disconnect must be within sight of the tub and at least five feet from the water. We run the conduit and wire, set the spa panel and connect to the tub's control pack.

Pool, sauna and swim spa electrical

Pool pumps, heaters, lights, saunas and swim spas each have their own requirements for circuits, GFCI protection and bonding. We wire new equipment and correct older installations that were never bonded properly.

Is your panel ready for a hot tub?

A hot tub is a large load. Before installing we check that your service has the capacity. If it doesn't, we'll go through the options, from load management to a panel upgrade.

Before your hot tub arrives in Texico, we'll confirm

• The amperage and voltage on the spa's nameplate
• Where the tub and the disconnect will sit
• The route from the panel to the pad
• Spare capacity on your electrical service
• Clearance from overhead lines and nearby outlets

Electrical work in Texico and Curry County

Summer heat on the plains means refrigerated air runs hard for months, and many homes in Texico also power a shop, a well or farm equipment from the same service. We check the total load before adding circuits and upgrade the panel when the numbers call for it.

Electric service in Curry County is typically provided by Xcel Energy or Farmers' Electric Cooperative, depending on your address. When a job involves the meter or the service wires, we coordinate the disconnect and reconnect with them. We provide hot tub electrical installation across Texico (ZIP code 88135) and in nearby Clovis, Cannon AFB, Portales, Saint Vrain and Broadview.

How it works

1. Call (888) 633-7804Tell us what's happening at your Texico property. Emergencies are dispatched straight away. Everything else gets a time that suits you.
2. Get a price firstThe electrician looks at the job, explains what's needed in plain language and gives you the price before starting.
3. We do the workWiring is installed to current electrical code, with materials chosen for the location and the load.
4. Tested and explainedEverything is tested, the panel is labeled where it applies, and the work area is left clean.

Hot Tub Electrical Installation FAQ for Texico