Whole House Surge Protection in Radium Springs, NM

Whole House Surge Protection in Radium Springs: what's included

• Panel-mounted whole house surge protector
• Dedicated breaker and short, direct wiring
• Grounding and bonding check
• Protection for sub panels and outbuildings
• Well pump and HVAC equipment protection
• Advice on point-of-use protectors

Surge protector installation in Radium Springs

A whole house surge protector mounts at the main panel on its own breaker. When voltage spikes, it diverts the excess to ground in a fraction of a second. Our surge protector installation in Radium Springs also checks the grounding system, because a surge device is only as good as the ground it dumps into.

Why surges are a problem in New Mexico

New Mexico's summer monsoon produces a great deal of lightning, and rural lines are long and exposed. Surges also come from inside the home every time a large motor starts, and from the utility when power comes back after an outage. Modern appliances are full of circuit boards that don't tolerate any of it well.

Layered protection for electronics

The best setup is layered: a panel-mounted device for the whole house, plus good point-of-use protectors for computers, televisions and network gear. We can also protect a sub panel in a shop or a well pump controller.

You should consider surge protection in Radium Springs if

• You've lost electronics after a storm before
• Your power flickers or drops out often
• You have a well pump, mini-splits or a new HVAC system
• You work from home on expensive equipment
• You're replacing or upgrading the panel anyway

Electrical work in Radium Springs and Dona Ana County

Summer monsoon storms bring lightning and outages to Dona Ana County, and in the mountains winter snow and wind do the same. For homes around Radium Springs that depend on a well or on refrigerated air in extreme heat, backup power is more than a convenience.

Electric service in Dona Ana County is typically provided by El Paso Electric, depending on your address. When a job involves the meter or the service wires, we coordinate the disconnect and reconnect with them. We provide whole house surge protection across Radium Springs (ZIP code 88054) and in nearby Dona Ana, Las Cruces, Fairacres, Rincon and Mesilla.

How it works

1. Call (888) 633-7804Tell us what's happening at your Radium Springs property. Emergencies are dispatched straight away. Everything else gets a time that suits you.
2. Get a price firstThe electrician looks at the job, explains what's needed in plain language and gives you the price before starting.
3. We do the workWiring is installed to current electrical code, with materials chosen for the location and the load.
4. Tested and explainedEverything is tested, the panel is labeled where it applies, and the work area is left clean.

Whole House Surge Protection FAQ for Radium Springs